DIN Mating Connector Cable for Pressure Transducers (16 ft)

This dedicated cable assembly is essential for establishing the electrical communication link between pressure sensors and the main control units in the car wash backroom. It serves as the data conduit, ensuring the 4−20 mA output signal from the pressure transducers is reliably transmitted to the controllers. Accurate signal transmission is absolutely vital for the automatic monitoring, troubleshooting, and regulation of the water treatment and RO processes.

The cable is specifically designed for integration with the Tommy RO Controller and the Water Treatment Center Controller. One end of the cable features a male DIN mating connector which plugs directly into the corresponding control board receptacle. The other end consists of wire leads which are connected to the transducer's terminal block, simplifying the installation process.

The generous 16 foot length of the P-WAT-2406 provides flexibility for proper cable management. This allows technicians to route the cable neatly and securely from the transducer locations on the pump skid or plumbing to the frequently wall-mounted control cabinets, minimizing clutter and potential damage in the busy backroom environment.