Dual Conveyor Belt Drive Shaft 2-15/16" Ends

This drive shaft is used in the Drive Section of the Dual Conveyor Belt inside the wash tunnel. This drive shaft connects to the chain couplers that connect to the other shaft in the drive unit to provide the power to move the conveyor belt throughout the system. One end of the shaft mounts into the chain coupler while the other end of the shaft mounts into a pillow block bearing. The sprockets slide over the drive shaft and help create the movement of the conveyor belt. The diameter of the drive shaft round ends are 2-15/16" while the square diameter of the middle of the shaft is 3-1/2".  This drive shaft is made of steel material and measures 44" long. It includes the 3/4" keyways needed for installation. There are two of these drive shafts needed in the Drive Section of the Dual Belt Conveyor system, one on each side of the gear motor.