Atlas Copco Series 1 Belt

The backroom environment of an express car wash tunnel places continuous thermal and mechanical stress on power transmission components. Inferior, low-grade replacement belts stretch rapidly under continuous loading, leading to belt slip, pulley glaze, and a severe drop in compressed air volume (CFM). This drop in system pressure directly threatens your lane operations—causing erratic entry gate response, dropping chemical injection pressures, and stalling automated tire-shining arrays. The genuine Atlas Copco 0367010057 belt eliminates these vulnerabilities with an advanced raw-edge cogged architecture (XPA profile) that maximizes wedging friction and completely blocks efficiency-robbing slip.

Key features and benefits include:

• Tailored for the Atlas Copco GX5: Custom-engineered to handle the exact horsepower outputs, pulley diameters, and rotational stresses of the 5HP GX5 compressor chassis.
• Molded Notch (Toothed) Construction: Flexes effortlessly around smaller sheaves to reduce internal bending stress, allowing the belt to run cooler and last significantly longer than wrapped smooth V-belts.
• Pre-Stretched Polyester Tension Cords: High-modulus internal cords minimize initial stretch and elongation, drastically lowering the frequency of manual belt re-tensioning.
• Oil, Heat, and Moisture Armor: The advanced fiber-reinforced EPDM rubber matrix stands up to airborne car wash chemical vapors, synthetic lubricant mist, and high-ambient utility room heat.
• Smooth Shock Dampening: Efficiently absorbs heavy start/stop torque spikes when the compressor cycles back to load, protecting your motor and pump shaft bearings from vibration damage.

Please call our Client Services team at 616-795-4893 with your serial number to ensure this is the correct belt for your air compressor.