Tire Shine Entrance Bearing Shaft Mount Arm 18"

This mount arm is used on the Tire Shine Applicator towards the exit of the wash tunnel. This mount arm is mounted onto the back of the Tire Shine brush and the bearing on the frame. It is the mount arm at the entrance of the Tire Shine Applicator. This mount is 18" in total length and has a 2-1/2" square diameter. There are two shafts, one on each end of the mount, that are 1-1/4" thick and stick out 2-1/4" on each side of the mount arm. There is a yoke mounted on the side of the arm that has a 1-3/8" inside diameter and is 2" tall. There are two holes on the yoke, one on each side, that are 1/2" in diameter. There is also a U-channel bracket on the side of the arm that is 3" long and has a 2-3/4" inside diameter. The six holes on the U-channel bracket are 7/16" in diameter. This mounting arm is made of stainless steel material to prevent rust and corrosion from occurring in the wash tunnel.