1-1/2" OD Wrap/Hugger Brush Stainless Stub Shaft 9" Long Hydraulic Motors

(0)No Reviews yet
$333.00
SKU: P-M2007-9

This stub shaft is used in the wash tunnel on the Hugger/Wrap brushes. This shaft is 9" long and has four mounting holes on the bottom that are 1/2" in diameter. The shaft connects to the wrap drive section on one end and the Hugger brush on the other end through separate flange bearings. This shaft has an outside diameter of 1-1/2" and an inside diameter of 1". It is made of stainless steel to prevent rust and corrosion from happening inside the wash tunnel. The round base of the stub shaft is 3-1/2" wide. This stub shaft is designed to be used with hydraulic motors only.

  • Length: 9"
  • Base Width: 3-1/2"
  • Shaft Outside Diameter: 1-1/2"
  • Shaft Inside Diameter: 1"
  • Mounting Hole Diameter: 1/2"
  • # of Mounting Holes: 4
  • Material: Stainless Steel

Ratings & Reviews

No reviews available

Be the first to Write a Review